Domoticz

Hi Guys,

I found out recently that i can't turn on the Moes ZM-105B-M dimmer anymore using Domoticz dimmer switch. I can switch it off, i can change level when but can't turn it on. I can also turn it on if i change the switch type in domoticz from "dimmer" to "on/off" but then i lose dim function which is weird.

As a workaround i created a dummy switch in domoticz which sends MQTT message to zigbee2mqtt/0xb0c7defffe1604c2/set {"state_l1": "ON"} but i would like to get my original domoticz dimmer type switch working fully if possible.

Any idea what is going wrong in my setup?

Thanks

Maybe you should tell us what versions of Domoticz and Zigbee2MQTT you are running?

I have to assume you updated them both to the latest version?

If not, 99% sure that solves your issue

When you do, check if you have received new devices as well

Thanks, good point. Domoticz 2025.1 and Zigbee2MQTT 2.4.0.

I dont see any new devices, all the devices discovered are below. I made device re-discover/re-join recently while i was trying to resolve the issue
I don't use the dimmer often, but i suspect the issue started post Zigbee2MQTT upgrade.

Thanks