Domoticz

Hi there.

I think I need a little help.....

I can´t get Domoticz to show right temperature data from my WSDCGQ11LM Aqara Temperature and Pressure sensor via zigbee2mqtt. Domoticz just show only text and not any data as you can see in picture.



But, it looks like Domoticz can see the sensor in right way....


All works fine in server as you can see in picture.



Domoticz server runs in an Raspberry Pi 3B+.

About Domoticz
Version: 2020.2
Build Hash: b63341bc0
Compile Date: 2020-04-26 13:47:55
dzVents Version: 3.0.2
Python Version: 3.7.3 (default, Jul 25 2020, 13:03:44) [GCC 8.3.0]

zigbee2mqtt

Sniffer CC2531

node --version = v12.20.0
npm --version = 6.14.10


Thank you for all help!


Happy New Year!


Best regard´s

McLund in warm and not snowy Sweden

Try to pair few times more by pressing buton on sensor for 6 sec. My was added after several tries.

Also try to plug off and plug in sniffer.

Hey rodaman.

Tnx for your tips, but hey Houston, we just got some new problems here.....

Now will the CC2531 sniffer shutdown (green lights turn off) after ca one minute after Raspberry reboot... This problem is new....

So I must find a solution on these sniffer problems first I suppose.

I will be in touched,


Best regard´s

McLund

Hi again.

Now is CC2531 sniffer up´n running again. I have just forget to run "sudo systemctl enable zigbee2mqtt.service"......

But, I can´t get Domoticz to show right temperature data from my WSDCGQ11LM Aqara Temperature and Pressure sensor via zigbee2mqtt. Domoticz only show text and not any real data as you can see in picture in my first post.

So, I would be very happy if anyone can help me with these case.

Best regard´s

McLund in colder Sweden