Domoticz

Would anyone know if it is possible to extend the P1 Smart Meter USB 'Meters/Counter' settings to include actual costs just like under the RFXMeters/Counters Dividers (see CostP1SmartMeter.JPG)

Using the hardware RFXCOM - RFXtrx433 USB 433.92 Mhz Transceiver I get this error below. I think because SET MODE does not save and not possible to define dB
2020-07-23 07:34:43.401 Error: RFXCOM: Invalid data received!....

If this is possible then I could actually see what my electricity actually costs.
Regards
Dutchy7

Dutchy7 wrote: ↑Thursday 23 July 2020 8:00 Would anyone know if it is possible to extend the P1 Smart Meter USB 'Meters/Counter' settings to include actual costs just like under the RFXMeters/Counters Dividers (see CostP1SmartMeter.JPG)

I guess you mis interpret the blocks on the tab. The costs for T1, R1, T2, R2 and Gas are (also) used for the P1 smart meter.

Hi waaren, yes I guess I have. Can you then explain where you see these total amounts? My dashboard widget does not show an amount. Neither in the 'LOG' is there any mention of a price total?

Dutchy7 wrote: ↑Thursday 23 July 2020 9:51 Hi waaren, yes I guess I have. Can you then explain where you see these total amounts? My dashboard widget does not show an amount. Neither in the 'LOG' is there any mention of a price total?

If you go to the 'LOG' and then click on 'Report' you will see a page where the costs are included.

Toppie! thanks that is what I was looking for. Much appreciated.