Domoticz

hi,

i bought some of these Smoke Sensors from Fibaro, but the temperature is not updated,
what i can see in the groups, is that the LifeLine is not 'connected' to the main controller.

if i want to link it to the main controller, the number1 (main controller) just doesn't shows up. Anyone else has this problem or knows how to solve?
Thank you.

Best Regards,
Stijn

Normally, i don't need to link it i think?

When i wake up my device by manually pressing 3x the b-button, it is sending the new temperature.

But it is not sending it automatically, and according to the parameters, it should send everytime when there is a change of 0.3 degrees.
And when there is no change, it must send every 10minutes (thats what i configured in the parameters)

This is my configuration: