Domoticz

Hi,

I recently bought some Kerui D026 door sensors.
Recognized by Domomitcz as an X10 Security Sensor.
It switches between Alarm and Normal status.
This is working when I press the switch in Domoticz and when I Open/Close the door where the Kerui is attached to.

Now I want to test a simple blocky however the script does not respond, no matter which trigger I use in the blockly script.
The Idea is to turn on a lightswitch for 2 minutes when the door is opened
I have attached an screenshot of the script.

Also in the log the blockly script is not triggered, but the sensor is logged when the door is opened or closed: Anybody an idea what is wrong

@ gschmidt the script is good, i have the same doorsensors by me working perfect but i think the rf signal is to far away , try the doorsensor in home and test if the script is working.