Domoticz

I'm having problems with my milight t2 wall switch adding to domoticz.
Accept new hardware, push button on wall switch, rflink/domoticz adds new device.
But when I use the new device nothing happens.
Domoticz only see the device switching off when i use the wall switch.
What goes wrong over here?

Nobody else using this switch?
Rflink is sending the following command when switching: 10;MiLightv1;02b2;01;0000;ON
Is this correct?
Just adding another switch T2 CCT, and thsi one isn't working either....
Rflink picks up the signal in domoticz, add device, but no response.
I can pair the bulbs in domoticz, but i want also use the switch.

Do you have "learn new device" enabled in domoticz settings, and enabled milight in rflink ? You need to also pair bulp with the switch.

Yes did that, domoticz can see the new switch, but the rflink is sending a total different command as the wall switch, so this is not working.
I f I give the wall switch command through the rflink command line in domoticz, it is working.
Hope this will be supported in next rflink release.....

Can you send me the commands that you logged?

Little late, but i did pair switch with bulbps, and thebn learned that switch press on domoticz.