1 wire ds18b20 [newbie]

[papajohnas]

Hello! this is my first time with domoticz and i can't handle with run ds18b20 connected to gpio4 as 1wire sensor.
First I checked wiki. using this tutorial domoticz can't find my sensors.
In terminal i can read id connected sensors

in domoticz my settings

what am I doing wrong? or what i don't see
regards

[emme]

try removing the OWFS parameter

[papajohnas]

try removing the OWFS parameter

if I remove OWFS parameter after refresh default parameter load /mnt/1wire
but this folder is empty.

[marcojpolet]

try removing the OWFS parameter

if I remove OWFS parameter after refresh default parameter load /mnt/1wire
but this folder is empty.

Did you add the pull up resistor?

Verstuurd vanaf mijn SM-G920F met Tapatalk