Domoticz

Hi there,

I've an issue. I like to switch my light in the hall (Fibaro Dimmer2) on with a value of 20% for 1 minute when the PIR is activated between 00:00 and 07:00. So far so good.

The problem is that the dimmer keeps the value of 20% and when operating with the normal butten, the light is on for 20%.
What I like is to have the 20% value only from the script and when operating ' normal' it should have the value of 100%.

Is this possible?

You could get the wall swith to trigger a group.
You can have just the hall light in it if you like, but then you can specify 100% from the wall switch.

Tried it, but doesn't work: Skipping sensor 'Lamp gang' because this triggers another scene!