Page 1 of 1

How to configure ICY E-Thermostat

Posted: Monday 11 December 2017 19:06
by g00fy
Hi Forum,

I bought a ICY E-Thermostat (Essent), because this device should be working native in Domoticz.
So, after registering it, I added it in the hardware settings, hoping I would find some devices under Settings..Devices or under the Temperature tab. But, unfortunately, nothing is there.

In the log I see:

Code: Select all

2017-12-11 18:52:23.076  ICYThermostat: Worker started...
but nothing seems to happen afterwards.

How can I troubleshoot this further? Are there any other logs or connections I can check?

Re: How to configure ICY E-Thermostat

Posted: Monday 11 December 2017 19:14
by jvdz
When you added the HArdware, 2 devices should appear in the Devicelist with the same name as defined in the Hardware tab.
Do you have "Accept new Hardware Devices " swicthed on ?

Jos

Re: How to configure ICY E-Thermostat

Posted: Monday 11 December 2017 19:21
by g00fy
jvdz wrote: Monday 11 December 2017 19:14 Do you have "Accept new Hardware Devices " swicthed on ?
:shock: Off coarse. That was the problem. I am such a beginner... ;)

Re: How to configure ICY E-Thermostat

Posted: Tuesday 12 December 2017 15:47
by jmartinr64
Dear.

I know that this message isn't post in the correct place. But somebody can told me if this device has been discontinued? Or where can I purchase it?

Thank you very much

Sent from my SM-G928F using Tapatalk


Re: How to configure ICY E-Thermostat

Posted: Tuesday 12 December 2017 16:10
by g00fy
It's in several shops (bol.com for example) for around €250. I bought mine secondhanded from Marktplaats. There ate plenty to buy from there.

Beware that you have to unregister the device on e-thermostaat.nl before you can register it under your own name. This process will cost €15.