Domoticz

Hello,

I have an OTIO WH5100 weather station (ref 810039).

Do you know if you can connect the radio sensors (temperature, hydrometer, wind) on Domoticz ?
Which receiver should I put on the Raspberry PI3 (Raspbian Stretch) ?

Thank you for your opinions.

Notice (French): lien mega

Kitras wrote: ↑Wednesday 01 November 2017 17:58 Hello,

I have an OTIO WH5100 weather station (ref 810039).

Do you know if you can connect the radio sensors (temperature, hydrometer, wind) on Domoticz ?
Which receiver should I put on the Raspberry PI3 (Raspbian Stretch) ?

Thank you for your opinions.

Notice (French): lien mega

In THEORY RFLink could handle it, but it's a 868 mhz device and RFLINK's 868 decoding capability is limited at the moment. For 868 Mhz Weather Stations, it could decode the following ones:

Weather Sensors:
Alecto ACH2010 weather station (868 Mhz - ASK modulation!)
Alecto DKW2012 weather station (868 Mhz - ASK modulation!)
WS3900 (868 Mhz!)

Alecto ACH2010 looks very similar, so you might get lucky here!

More info, building guide, etc here: http://www.rflink.nl/blog2/

Thank you Louis,
Very interesting answer.

I need to make a RFLink 868Mhz ...
I'll tell you if it worked (but it will take time).

I finally bought the RFPlayer. It detects the Somfy RTS shutters well but none of my temperature probes and not the OTIO WH5100.
I tested in 433.92 and 868.35.

RFPlayer driver for Domoticz: sasu-drooz v1.0.7
Domoticz beta v3.8739

Hello,
I built a RFLink 868Mhz, and my OTIO WH5100 weather was detected quickly. I think it must be in beta because on a stable Domoticz v3.9700, I did not detect it, but I did not think to go into beta on this Raspberry.

The RFPlayer firmware v1.34 still does not see it.

Résult:


There is no wind tonight ...