Domoticz

Hi everyone.

Today i added the cc2500 on the rflink. Enabled via the tool and status ok. however it dont have the orginal remote voor the ansluta. therefore i try to add the device via the command. when doing it says device created , but its not listed anywhere.

the command is 20;4C;ANSLUTA;ID=d3d2;SWITCH=0;CMD=ON;

Question is if its possible to pair without remote. as the remote needs to be pressed few sec's that is sending the device id to the receiver.

small update.. i received beta version rflink v47 that supports pair function. i know can send commands. however when try to add device via rflink with command stil no device is showing under new devices......

It now give me in the log : RFLink: Unhandled switch type