Domoticz

I installed three temperature sensors in my swimmingpool on different heights, connected to Domoticz using a Fibaro binary sensor through Z-wave. The idea is to gather enough data to optimize the pump with and to check the effect of our solar deck.

Unfortunately, one of the sensors for whatever reason returned a false reading of 0.0 degrees. This disturbs the graph Domoticz can draw: The "zwembad onder" has a false reading at 17:20 hours today. If I remove the whole sensor from the graph, autoscaling works again, showing some useful information on bottom and middle sensors. So, the bottom line question: is there a way to remove (or better: to edit) that false reading from the Domoticz database? If so, how? I run Domoticz on a RPi3, latest stable version if that is of any importance.

Yes, you can remove them. Hold your [shift] key on your keyboard and click on the bad data point. This should pop up a window asking you if you would like to remove it.

I think there needs to be more ways to edit this information though. Perhaps a table view.

Hope that helps!

Ah, works like a charm, thanks!
Yeah, it sure would be nice if we could edit in the table view.