Page 1 of 1
Neo Coolcam flood sensor
Posted: Tuesday 25 July 2017 22:41
by petzno
I just included one of these to Domoticz:
https://www.aliexpress.com/item/NEO-COO ... 0.0.dUNXgw
It does not seem to show the battery level in Domoticz, although I can find it in OpenZwave control panel so it is supported by the device. Anyone been able to get battery status for this flood sensor in domoticz?
Re: Neo Coolcam flood sensor
Posted: Wednesday 26 July 2017 9:43
by LouiS22
Yes, it's there.
Re: Neo Coolcam flood sensor
Posted: Wednesday 26 July 2017 11:32
by petzno
Seems like it arrived today after the 12h update interval.
The attached shows what the flood sensor is presenting. Seems like several of them is able to act as the alarm switch?
- IMG_0043.JPG (136.46 KiB) Viewed 1600 times
Re: Neo Coolcam flood sensor
Posted: Wednesday 26 July 2017 18:17
by remb0
But I don't think it works: My sensor is 7 months online but still 100 percent
Re: Neo Coolcam flood sensor
Posted: Wednesday 26 July 2017 21:57
by LouiS22
remb0 wrote:But I don't think it works: My sensor is 7 months online but still 100 percent
Yeah I noticed with other sensors - even with Fibaro, so it's not a cheap chinese problem. Also: haven't found a proper solution
Re: Neo Coolcam flood sensor
Posted: Thursday 27 July 2017 21:00
by petzno
If the sensor is not activated too much it could still be showing 100% even after months. As mentioned here this also applies to Fibaro. The problem is that suddenly they are dropping fast.
Re: Neo Coolcam flood sensor
Posted: Thursday 03 August 2017 10:23
by EddyG
In the previous stable version of Domoticz it showed 100%. In the current version V3.8153 it does not show any battery level.
I have a Domux DX1SA-Z which shows 98% in de OpenZwave Control panel, but nothing is showed in Domoticz.
Does anyone knows a manual way to interrogate a RaZberry ZWave devices to see if data is send?