Domoticz

I have just received my new multisensor Fibaro FGMS-001. Included in the network by using the Aoen z-stick gen 5. This was succesfull
However when I look at the node list the node is unknown and in probe (sleeping) state. See attachment.
I have read this state is normal because it is a battery powered sensor. But when I trigger the motion sensor still nothing happens in domoticz.
In the OZW_log I see the following:

2017-07-21 15:59:20.261 Info, Node008, ApplicationCommandHandler - Unhandled Command Class 0x71
2017-07-21 16:00:02.797 Warning, WARNING: Out of frame flow! (0x05). Sending NAK.
2017-07-21 16:00:02.799 Detail, Node008, Received: 0x01, 0x10, 0x00, 0x04, 0x00, 0x08, 0x0a, 0x71, 0x05, 0x00, 0x00, 0x00, 0xff, 0x07, 0x00, 0x01, 0x08, 0x6c
2017-07-21 16:00:02.799 Detail,
2017-07-21 16:00:02.800 Info, Node008, ApplicationCommandHandler - Unhandled Command Class 0x71

Any idea how to get my sensor recognized correctly by Domoticz?

this does not seem to be added properly, have you tried to exclude and include again?

Yes I just excluded and included to the network again. Reconnected the USB stick, but still no difference unfortunately.

Now I tried it through the domoticz interface (not with the USB stick) to include and it was succesfully recognized.