Domoticz

I have a 1-wire setup and a DS2438 that gives humidity. Domoticz sees this fine and correctly shows me the humidity (63% at the moment). But if I push this value to influxdb (using http or the influxdb data push in the beta) the value sent is "3".

Any ideas why?

Cheers,

F.

why post the same question 2 times? http://www.domoticz.com/forum/viewtopic ... 28&t=17952 I don't think you get an answer sooner

Because I don't know if the problem lies in the fact it is a 1-wire issue or data push issue... but don't let that stop you making replies that actually help find a solution.