Domoticz

Hello,
do you have have an idea why this small blockly creates an error? I reduce it to the minimum and use the time as a trigger (>= 07.00)
I want to set the temperatur in my bathromm (Bad) of my POPP thermostat and get´an error
2017-03-11 07:48:00.045 EventSystem: Event triggered: Bad_1
2017-03-11 07:48:00.045 Error: EventSystem: Malformed action sequence! I tried the similar with sending an email - this is working.
2017-03-11 07:48:00.045 EventSystem: Event triggered: notifi_1
2017-03-11 07:48:01.840 Notification sent (Email) Thx´s a lot for your help.

cheers Thomas

If i recall correct, you can't use xxxxxactual to define a setting.
You should use

thx´s.
I´ll upgrade to the latest beta (3.6944). I´m still running Version: 3.5877 and it´s not included.

Hello, I updated to the beta Version: 3.7349.

I don´t see the option "setpoint" inside blockly.
Setpoint works directly/manually with the Danfoss Popp Radiator before and after update.

I see at this link http://www.domoticz.com/forum/viewtopic ... 78#p108045 how it should look like inside blockly (the menuoption at the bottom).

Is there a config option in general to enable the "setpoint" or any other ideas?

thx´s in advance
cheers Thomas

addendum: my devices are subtype: setpoint