Aeotec Multisensor 6 in sleep mode

[shaneben]

I've searched the forums but can't find a clear answer to this problem. I have the Aeotec Multisensor 6 added to the Hardware but it's always asleep. I'm using the Aeotec ZStick Gen 5 and they all show up fine in the Hardware. I'm on a Raspberry Pi 3 using Domoticz ver. 3.5877.

The sensor is on battery power and it seems like if I shake it the LED goes off but it doesn't detect motion. Hoping someone could point me in the right direction.

Thanks

[shaneben]

I was able to get it going but not sure if it was the full nuke and pave of the RPi or the settings from this forum post: viewtopic.php?t=8998&start=20 specifically the settings posted by user Dnpwwo 13/03/2016 21:52

Either way it's working hopefully this saves someone else some time.

Thanks