No devices appearing after adding OTGW to Domoticx
Posted: Thursday 02 February 2017 20:33
I connected an OTGW by using wifi over an ESP12.
I added the OTGW by using its IP adress and port 23. The Opentherm codes are coming in successfully in the Domoticx log.
However, There are no new devices visible, no sensors, nothing...
What am I doing wrong?
I added the OTGW by using its IP adress and port 23. The Opentherm codes are coming in successfully in the Domoticx log.
However, There are no new devices visible, no sensors, nothing...
What am I doing wrong?