Danfoss Living Connect 014G00012 OZW integration
Posted: Thursday 29 December 2016 18:43
Hello Domoticz fans,
since few months I'm playing around with Domoticz system and so far so good
Have integrated RS485 (SDM120), MySensors, 1-Wire sensors and works pretty well.
Now I decided to try with OZW, so I bought Aeon Z-WAVE Plus Gen5 stick, installed new hardware (pictue below):
and what next? Shoud I see controller it self when I click "Setup"?
This's what I see now:
My first Z-WAVE devices that I try to integrage is Danfoss living connect 014G00012 SW 2.51 (OZW support).
I've tied Node Management -> Include node/secure node -> press "discovery" (middle button on thermostat) in mode "Li" on device it self, but nothing apears in Domoticz
Does anyone of you integrated those devices, how to work with it?
Best,
since few months I'm playing around with Domoticz system and so far so good
Have integrated RS485 (SDM120), MySensors, 1-Wire sensors and works pretty well.
Now I decided to try with OZW, so I bought Aeon Z-WAVE Plus Gen5 stick, installed new hardware (pictue below):
- 01.PNG (34.15 KiB) Viewed 1111 times
This's what I see now:
- 02.PNG (113.88 KiB) Viewed 1111 times
I've tied Node Management -> Include node/secure node -> press "discovery" (middle button on thermostat) in mode "Li" on device it self, but nothing apears in Domoticz
Does anyone of you integrated those devices, how to work with it?
Best,