Domoticz

Hi,

I have bought a Etekcity Smart Wireless Electrical Outlet from amazon.ca (https://www.amazon.ca/Etekcity-Wireless ... cal+Outlet)

i try to control it from domoticz through Rfrxtrx433,

In RFXmngr, i can turn on and off the outlet (housecode=H, unitcode=1-3)

By can't add it as dimmer to domoticz, only housecodes A to D are available for Energenie 5-gang ?
================================================
Lighting1 command
================================================
Packettype = Lighting1
subtype = Energenie 5-gang, Etekcity
Sequence nbr = 3
housecode = H
unitcode = 3
Command = Off
Signal level = 0 -120dBm

is there a way to get it work in domoticz ?

Did you get this working at all ?

After some fiddling I got mine working on latest firmware 1015 and latest Domoticz beta 3.6707 - it will not auto-detect but manual switch adding works fine - you might have to change the house number settings "J" worked for mine perfectly http://imgur.com/a/dQOzh

I have received a 5pack today.

I have been able to auto create the switch automatically (using Rflink usb on a Pi3). The devices are detected as TriState.

regards,
Miguel

Received a pack of 5 this week. Couldn't have it added automaticaly (Domoticz Version: 3.7324 and RFXCOM - RFXtrx433 USB 433.92MHz Transceiver Version: Ext/1015).

Found Housecode A and unitcode 5 or 10 can control all the plugs at once (on and off) but couldn't find a way to control each of them.

Contacted RFXCOM team, my model is not supported :

"The supported version is a P300 type and your version is a ?Rx type.
The Etekcity P300 remote is not received but you could add the Energenie5 device as an additional remote to the module."

Then I put each of the plugs in learning mode, one by one, and send each of them the house-unit combination I decided for each of them and it works. It was added has another remote, it didn't replace actual remote. Thus I can use each of the remote using Domoticz and the genuine remote.