Domoticz

Hi

I have just connected my miloght bridge and it seems to work great turning on and off.

I was going someone could help, domoticz does not seem to hold the correct state of the lights, for eg it will show that the lights are off when the are actually on or vice versa

Can anybody help?
Regards

Do you mean when you switch them on/off with Domoticz? That should work without a problem. But when you turn on/off the lights with a mii light remote Domoticz will not know because it's one directional communication.

Note that when you use RFLink to act as a bridge then also state changes caused by remotes are recorded.
Unlike the milight bridge which can only transmit, RFLink can also receive milight signals.

Some times I have the same issue when used the physical switch instead the virtual switch.
All my light switches are Aeotec Micro Smart Energy Switch G2