Domoticz

Hello


Anyone knows if Domoticz (v2.4460) is working with the Netatmo wind gauge please or this has not been implemented yet?


Thanks
Alex

I have the Netatmo wind sensor, and it works fine on all version of Domoticz that I have used since I bought it. This includes the latest stable version and a number of beta versions. Two remarks:
- The resolution is a bit worse than with the 433 MHz wind meter I had before (I believe the resolution is just below 1 m/s)
- It reports a windchill temperature, but that is always zero. Probably because it doesn't have an internal temperature sensor, in contrast to most 433 MHz wind meters

Hello

I am a new guy of Domoticz use on Raspberry pi. I refer mvzut' post told the Domoticz worked with Netatmo Wind gauge. I would like to got more information.

Does the Domoticz need the Netatmo Weather station as a bridge to talk with the Netatmo Wind gauge, or talk with the Wind gauge directly. And what hardware request need ? how about the setup on the Domoticz ?

Best Regards
Francis

mvzut wrote:I have the Netatmo wind sensor, and it works fine on all version of Domoticz that I have used since I bought it. This includes the latest stable version and a number of beta versions. Two remarks:
- The resolution is a bit worse than with the 433 MHz wind meter I had before (I believe the resolution is just below 1 m/s)
- It reports a windchill temperature, but that is always zero. Probably because it doesn't have an internal temperature sensor, in contrast to most 433 MHz wind meters

Hello, can you provide more information on how to talk with the Netatmo Wind Gauge ? I cannot found any useful information, except the window gauge operate in 868 /915MHz.

Thakns in advance.

Br
Francis