Domoticz

Hi all,
I would like to find c couple of temperature/humidity sensors that will work with either rfxtrx433e (NOT Oregon mode though!) or with z-wave.

Reason why not Oregon, I have byronSX mode active.

Any suggestions for a temperature/humidity sensor that ISN'T Oregon scientific?
Cheers

Stuart

stuiow wrote:Any suggestions for a temperature/humidity sensor that ISN'T Oregon scientific?

Did you search in the forum? I have three Cresta TX-320 using rfxtrx433e

Yeah I searched for through the forums and other forums using Google. Got some good results but none gave definitive advice on "non-oregon" devices.
I'll take a look at the Cresta TX-320 then, cheers.

Sent from my SM-G925F using Tapatalk

You can also use Oregon 1.0 or 2.1 sensors together with ByronSX enabled.
THR128
THR138
THC138
THC238/268
THN122N/132N
THWR288A
THRN122N
AW129
AW131
THGN122N/123N
THGR122NX
THGR228N
THGR238/268
RTGR328N
THGR328N
THGR918
THGRN228NX
THGN500
BTHR918N
BTHR968
RGR126
RGR682
RGR918
WGR918
UVN128
UV138
RTGR328N

Are there different modes to enable for Oregon 1.0/2.1 against 3.0?

I did use a Owl 168 energy monitor but that blinded the ByronSx signals.

There is only one Oregon enabled for all Oregon sensors.
OWL sensors use the Oregon 3.0, except CM113 which is using 2.1

So by using one of those listed sensors above that use oeogen 1/2, it won't cause issues with my doorbells? I want to ensure when the bell pushes are pushed, domoticz see them.