Page 2 of 2

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Monday 15 February 2016 13:41
by Westcott
It looks like it reports only when its temperature changes by 1 degree.

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Monday 15 February 2016 16:31
by mvank
Yes i though it was the 1 degree, but when i hoover over the line, it tells me on the flatline parts that it received an update every 5 minutes.
Also as you can see, i doesn't report anymore since 13:05
Schermafbeelding 2016-02-15 om 16.29.16.png
Schermafbeelding 2016-02-15 om 16.29.16.png (72.53 KiB) Viewed 1410 times

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Monday 15 February 2016 18:25
by stuiow
Sorry to butt in, got similar setup, but with the FGSD-001.
Do these along with Domoticz actually log smoke levels?
I was hoping for this, but all I see in the log is either 100% or 0% (alarm active or deative in other words).

Hoping to measure smoke levels really (we have a log burning stove, would be handy to monitor smoke in area's of the house)

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Thursday 25 February 2016 20:16
by mvank
unfortunately still not working as hoped.
reinstalled RPI, with pre-build image.
resetted Aeon USB stick,
resetted smoke detector fgsd-002

still temp sensor not reporting :(

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Friday 25 November 2016 12:53
by gooxbe
I have the same,

Z-Stick Gen5 0701 1 DF - cuisine - temp Temp LaCrosse TX3 24.2 C - 100 2016-11-24 19:49:17
33 Z-Stick Gen5 0601 1 DF - SAM - temp Temp LaCrosse TX3 20.2 C - 100 2016-11-24 18:33:57

Not reporting since yesterday when I re installed them...
I put the setting to report every 0,2CĀ°and still...

Anyone have found a fix?

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Tuesday 29 November 2016 20:59
by mvank
i had to have patience, after several hours it was working fine.
only my battery of smoke detector is almost empty after 9 months,,,, this is not ok...
Also want to increase the number of temp value per month, now i can only see min and max value for older then 24 hours

Re: Can get the fgsd-002 smoke detector into Domotics

Posted: Thursday 15 December 2016 20:02
by hoedinie
I installed 2 sensors and both show big gaps as well in temperature reporting. Anybody already found a fix for this?