Read Arduino Analog values through Mysensors

Moderator: leecollings

Post Reply
domoticzag
Posts: 24
Joined: Tuesday 13 September 2016 19:39
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

Read Arduino Analog values through Mysensors

Post by domoticzag »

Hello,

I am still quite new in domoticz, and trying to figure out if there is a way to read the analog values of my Arduino into a 'virtual device' in domoticz. Preffered via USB connection on the rapberry pi 3 (running domoticz) and the arduino.

I have googled all day, but can only find topics and blogs about using the arduino as serial gateway and other arduino's as devices. But all i want is to read my arduino analog value, make a calculation (on the arduino) and send it to a device on domoticz.

Is MySensors the right way to do this?

Thanks in advance!
RPi 3
Domoticz Béta
RFLink Gateway dipool antenna
Many kaku devices
P1 smart meter
Custom made ESP8266 devices
Hue lights / Milight ligts and strips
Flopp
Posts: 279
Joined: Sunday 03 January 2016 14:55
Target OS: -
Domoticz version:
Location: Sweden
Contact:

Read Arduino Analog values through Mysensors

Post by Flopp »

That should be possible to do with MySensors.
Start configure an arduino with MySensors code, that can read the analog signal and your calculation when that is working you can add Domoticz as controller.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest