RFLink support

[jumping]

Hello,
yesterday I tried RFlink with Domoticz on Raspberry Pi3, but without success: I didn't see any devices recognized in Domoticz ( I have a PIR sensor and a temperature an humidity sensor). Then I tried with Rflink with RFlink loader v1.08, this is the log window:

20;00;Nodo RadioFrequencyLink - RFLink Gateway V1.1 - R42;
10;version;
20;01;VER=1.1;REV=42;BUILD=0a;
10;rfdebug=on;
20;02;RFDEBUG=ON;
10;ping
10;ping

So I think that the RFlink doesn't work, what do you suggest? may be the problem is the arduino clone?
I have a Robotdyn Mega CH340/ATmega2560 and a RFlink gateway with Aureal tranceiver by NODO-Shop

I really appreciate any help you can provide.

[Stuntteam]

You can contact me directly via [email protected] for support...

[jumping]

You can contact me directly via [email protected] for support...

Hello! thanks Stuntteam but I find the solution: a wire between GND pin on Arduino and GND pin on RFLink PCB !!
I don't know if this is a well known rule or not...

[Stuntteam]

the rflink pcb has seperate ground and vcc connections.. no additional wires shoudl be needed.
Unless you did not solder those points.