Hi,
I purchased one Nexa WST-512 switch with a dimmer support. It is recognized in the system and works fine, but after some time it "changes" the code or something and appears as another switch in the system. Maybe is it because of its dimming capability. Is that "known" behavior or is there some way to configure the swithc?
I also have one LWST-605 double switch i have not yet tested. I can provide logs if that can help
Thanks!
Nexa switches support?
Moderators: leecollings, Stuntteam
-
dakipro
- Posts: 49
- Joined: Thursday 17 December 2015 22:24
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 3.5877
- Location: Norway
- Contact:
Nexa switches support?
Raspberry Pi 2 B - MySensors (dimmers, switches, motion, temperature, lux, humidity sensors)
zWave (220v switches)
various 433 via RFLink
zWave (220v switches)
various 433 via RFLink
-
Stuntteam
- Posts: 399
- Joined: Wednesday 06 May 2015 16:39
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Nexa switches support?
Could be a bug, the ID should not change just like that.
See PM.
See PM.
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Who is online
Users browsing this forum: No registered users and 0 guests