RazBerry Z-Wave and Smartmeter P1 To USB

[baltusf]

Hi,
I'm new here. I have configured my Rapsbery Pi/RazBerry Z-wave via OpenZWave USB (ttyAMA0==ttyUSB20) in domoticz. Now i have to connect my P1-to-usb-cable also to my Raspberry and Domoticz. How must i do that? I think i can't use a second time the ttyUSB20 ? Must i configure the RazBerry via "RAzBerry Z-wave via lan interface (http)". MUst i then enter the ip-adress with a specific port 8083? Or must i use the Z-wave device via the controlpage of the Z-wave page?

Thanks,
Fred

[bbqkees]

No you do not need to change anything about the Razberry setup.

Just do the following: http://www.domoticz.com/wiki/PersistentUSBDevices

[baltusf]

Thanks, it's working now, it's connected to ttyUSB0 now and works fine