Hi,
I bought a rflink gateway. I do receive info with a temperature and humidity sensor.
Now I would like to control my switch chacon.
If I press a button on the remote controller of the switches, domoticz recognizes the device.
But I I tell domoticz to switch on or off the switch, it tells me that they is a transmittion error, plkease check the device !!!
Could it be possible that there is a pb with the 433 emettor ? on the rflink gateway ?
It seems it recezive very well, but I got a doubt with the tramsission.
Or perhaps I do something wrong with domoticz and the asssociation process ?
Thank you for your help.
RFlink and Chacon dio switch on/off
Moderators: leecollings, Stuntteam
-
- Posts: 8
- Joined: Tuesday 02 February 2016 10:36
- Target OS: NAS (Synology & others)
- Domoticz version:
- Contact:
- Stuntteam
- Posts: 399
- Joined: Wednesday 06 May 2015 16:39
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: RFlink and Chacon dio switch on/off
RFlink works with the Chacon switches.
Make sure you use rev 37 of the RFlink firmware.
Make sure you use rev 37 of the RFlink firmware.
-=# RFLink Gateway Development Team #=-
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Introduction: http://www.nemcon.nl/blog2/
Generic RFLink Support forum: http://www.esp8266.nu/forum/viewforum.php?f=8
Who is online
Users browsing this forum: No registered users and 0 guests