Moes BRT-100-TRV

[har0543]

Hello,
I have a Moes BRT-100-TRV, a Thermostatic radiator valve.
It works in the Tuya smart life app.

In the domoticz plugin it is found but not correct:TS0601 - EndDevice


In zigbee2mqtt there is an item about it: https://github.com/Koenkk/zigbee2mqtt/issues/3821

But I can not figure out what to with it in domoticz.

Any ideas?

Har

[pipiche]

Are you using z2m or an other gateway ?

[har0543]

I am using v.1.19.1 (zStack12 20201127) zigbee2mqtt

[waltervl]

Should be working in zigbee2mqtt https://www.zigbee2mqtt.io/devices/BRT-100-TRV.html

[har0543]

should but is not the case

[waltervl]

In this discussion it paired without issues: https://github.com/Koenkk/zigbee2mqtt/discussions/9155

Perhaps try again to pair and keep the thermostat close to the ZigBee USB stick.

[Patricen]

Can this device operate with Conbee II?

[waltervl]

Can this device operate with Conbee II?

That mostly depends on the controller/plugin software you use, Deconz, Zigbee2MQTT, Zigbee4Domoticz.
Checkout the appropriate repository for supported devices.

The problem is that each stick can zigbee pair with it but the information has to be rendered correctly into Domoticz devices. If a device is not known yet it could lead to incorrect behavior. Make an issue then on the plugin software to get it correctly supported.

[Patricen]

I'm currently using Deconz but it looks like setting up a mqtt broker would be a good migration for both Z-wave and Zigbee networks,
I would then be using Zigbee 2mqtt if I understand well.

[pipiche]

otherwise you can use Zigbee4Domiticz plugin with the deConz and you don't need any middleware like a mqttbroker