Problem with OZW in 2022.1 14223

[harrykausl]

Toaday I included a new Fibaro FGS 213 to my system. I'm on this beta because of problems with enocean. Including worked, devices are created. Then I wanted to change the settings of the switch in the hardware zwave panel. I change the value (for example the name) and select write configuration for this device, but nothing happens. Then tried to change another z-wave hardware, same effect. I have a sd-card with my old 2021.1 and bootet with this, to see, if the error was there too. It was. It seems, that the error was migrated. I remember, when I switched to 2021.1 I had to delete the ozwcache and wake up the devices. Then everything worked. Could this be the solution for this problem too. I stop domoticz, delete ozwcache, restart domoticz and wake up all my batterie devices.

[harrykausl]

Next problem. After several reincludes, I could change some settings. I have a toggle switch on s1 and customized it as toggle switch, contact close on, contact opened off. This works now. Light gets on, when I push my hardware switch connected to s1 to on off too. But switching from domoticz doesn't work. I push the device, it shows on, but nothing happens. Any idea?

[waltervl]

Perhaps start with clearing all your browser cache.
https://www.domoticz.com/wiki/Browser_Cache

[harrykausl]

I did this already several times. I have no cache problem, because I see everything. The problem is, that zwave seems not to work. When I push the switch from domoticz the symbol shows on, but the real light is off. With the external onoff attached to the Fibaro it works. Perhaps the switch is damaged.

[waltervl]

Domoticz UI is heavily build on Javascripts. If there was a change in these scripts they sometimes are unnoticed but could introduce unexpected behavior.

Perhaps try to open Domoticz in a browser window in private (or incognito) mode. Then all javascripts are forced to reload.