RFXCom Firmware Question Topic is solved

Moderator: leecollings

Post Reply
markk
Posts: 267
Joined: Tuesday 14 January 2014 14:50
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

RFXCom Firmware Question

Post by markk »

For the past 5 years or so I have been successfully using Domotixz RFXcom to operate my Louvolite one touch blinds until last week when the lithium battery gave up. It was then I found out that the r1710 motor was discontinued and replaced with the r1912. I installed the new motor and followed the process I did before to flash the RFXcom with type 2 firmware in order to learn the blinds T0 code but it didn't receive anything. I did manage to get it to learn the code by selecting blinds T1.
The issue I have now is that when I revert to the usual EXT 2 firmware, the blinds wont work. they will work with the type 2 firmware but when I use this I can't receive data from my owl energy monitors.
I hope this all makes sense. I'm basically asking is there a firmware which I can use to operate both owl and the new Lovolite blinds?
Running Domoticz on Pi3 with RFXtrx433e. LWRF power sockets and dimmer switches. Integrated my existing wirefree alarm PIRs and door contacts with domoticz. Geofencing with Pilot. Harmony Hub. Tado for Heating. Now playing with mysensors.
markk
Posts: 267
Joined: Tuesday 14 January 2014 14:50
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

Re: RFXCom Firmware Question

Post by markk »

markk wrote: Thursday 05 August 2021 21:02 For the past 5 years or so I have been successfully using Domotixz RFXcom to operate my Louvolite one touch blinds until last week when the lithium battery gave up. It was then I found out that the r1710 motor was discontinued and replaced with the r1912. I installed the new motor and followed the process I did before to flash the RFXcom with type 2 firmware in order to learn the blinds T0 code but it didn't receive anything. I did manage to get it to learn the code by selecting blinds T1.
The issue I have now is that when I revert to the usual EXT 2 firmware, the blinds wont work. they will work with the type 2 firmware but when I use this I can't receive data from my owl energy monitors.
I hope this all makes sense. I'm basically asking is there a firmware which I can use to operate both owl and the new Lovolite blinds?
This is solved. I managed to get both working using Version: Ext2/1025 firmware.
Running Domoticz on Pi3 with RFXtrx433e. LWRF power sockets and dimmer switches. Integrated my existing wirefree alarm PIRs and door contacts with domoticz. Geofencing with Pilot. Harmony Hub. Tado for Heating. Now playing with mysensors.
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest