Qubino Flush 2 relay with push button controll

[dagger38]

Hi
I have got 2 flush 2 relay switches from qubino.
I want to switch these on and off with a push button.

Push button is connected to I1.
the Q1 output is set to mono stable switch type (push button)

Problem , when i press the button the light go's on , if i release it , the light go's off??
Shoudln't the light stay ON untill i push the button one's again??

Or what am i douing wroung??

Thanks

[Denny64]

I also have some Qubino switches and they work properly with Domoticz. The only flaw I found is a very frequent latency, and it's not possible to put them inside a scene..

For your problem, try to exclude them from the network and reassociate them by changing parameters 1 and 2 again.

Do not forget to save the configuration, press update and select the Qubino switch again to see if the parameters have been correctly saved.

[dagger38]

going to try that
Thanks

[akamming]

Hi,

i installed this device, including the temperature sensor (ZMNHEA1 according to docs). The connector of the sensor fits nicely into the device. However i don't see any temperature readings.

I already enabled polling and set configuration param 120 (Digital sensor reporting) to 1. Do I have a faulty device or am i doing something wrong?

UPDATE: fixed it. I did a factory reset, and then re-included the device with the temperature sensor attached during inclusion. This did the trick. Temperature is now reported!