Hi all,
I just installed a Daikin (FTXM50N / 2020) with a WiFi controller. After networking, I have normal operation of the Daiking app on the smartphone.
Following the wiki https://www.domoticz.com/wiki/Daikin_wifi:
- In the hardware configuration, I add "Daikin Airconditioning with LAN (HTTP) Interface"
- I set the IP address, the port (80), login and password and I add the equipment to the list ....
BUT .... I don't see the 3 new devices appearing (the inside temperature, the outside temperature and the target temperature).
Did I miss something?
Best regards
Philippe
-----
Domoticz 2020.2 / Raspberry Pi 3 / Linux 10 (buster) / Dzvents 3.0.2 / Python 3.7.3
Daikin hardware setup and devices
Moderator: leecollings
-
- Posts: 33
- Joined: Wednesday 27 November 2019 13:31
- Target OS: Linux
- Domoticz version: 2024.7
- Location: France
- Contact:
Re: Daikin hardware setup and devices
Without doing anything, now I have 2 devices: "Outside temperature" and "Home temperature" but still not "Target temperature" .... strange
-
- Posts: 9
- Joined: Wednesday 11 November 2020 10:17
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Daikin hardware setup and devices
Hello
i had the same issue
i had to wait a moment to see 8 new devices
i had the same issue
i had to wait a moment to see 8 new devices
-
- Posts: 20
- Joined: Thursday 26 October 2017 19:47
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Daikin hardware setup and devices
Hi,
From where did you get the login and password?
I dont remember having been afsked to define that anywhere.
Only for my daikin online account. Is it this?
Br
Ar
From where did you get the login and password?
I dont remember having been afsked to define that anywhere.
Only for my daikin online account. Is it this?
Br
Ar
Who is online
Users browsing this forum: No registered users and 0 guests