Neo CoolCam Power plug (wifi) with Tasmota Topic is solved

[Chris12]

Hi,

I have flashed a Neo CoolCam Power plug (wifi) with Tasmota, and set it up with the correct template.
Via the Tasmota config page I can switch on/off and I can see voltage/usage results there.

In domoticz I created a dummy device with a P1-smartmeter, and I added this IDX number into the Tasmota config.
But somehow I cannot see any usage/results from this power plug (I have a RPi connected to it, so a small amount of Watts are used).

Am I missing a step somewhere in the configuration?

[Chris12]

Solved it myself.

I was missing the MQTT config (had to install a MQTT package on my NAS), and I also had to fill in the virtual switch idx for idx1 in Tasmota, and my other P1 for idx10.