tonbor wrote: ↑Monday 18 March 2019 20:48
Yes it works, easy setup, AAA batteries, and the discription tells that you need to replace the batteries after 2 to 3 years.
as i know.. the door sensor are not zwave certified.. and price is higher a lot than neo coolcam door sensors
Yep I tried connecting my dishwasher. No joy. The plug went into safe mode (ref flash) because of too much power drain (more than 10 amps). After unplugging the plug was reset and it works fine.
Odroid N2+ 4GB, with an RfxTrx433E, Zigbee with Slaesh's CC2652RB, Z-Wave, BroadLink IR using RM mini 3 and P1 connected.
I have 4 Heiman HS1SA-Z smart smoke sensor - I try them to include on the Aaotec Zwave USB dongle which is connected to a Raspberry Pi with the latest version of Domoticz (4.10629) All other Zwave sensors (like thermostat, door switch etc) are working - but I keep unknown in the list for these Heiman sensors - I already removed battery and puch the reset button to restore the sensors to factory default as wel I exclude the sensors first from the Aeotec USB - then I try to include - without succes; I can't get Heiman Sensor in the hardware list of Zwave clients ;( - I have also a CO sensor from Heiman - installed a couple of months ago without any problem... can somebody advice me?
Hi friends, I bought this product on AliExpress, the association with domoticz is correct, but I don't see devices to select. In the hardware part, it appears and assigns its node ID.
NEO Coolcam Smart Home Z Wave Plus interruptor de cortina inteligente para cortina motorizada eléctrica persiana enrollable
Can't even find the manufacturer in:
domoticz/Config/
So no support. Could be done with full documentation by you, following OZW lib developers directives, but that's an added difficulty. Especially if documentation is bad.
Anyway, my advice is always the same: Avoid 220V powered stuff from pure Chinese manufacturers. Stick to battery ones, less fire prone... Very bad experience with Neo in the past.
