Sleeping devices lost at re-start

[jeleve]

Hello everybody,
I just have upgraded Domoticz to the 2020.1 version on a Pi 2 B under buster. My network uses an Aeon Z-stick Gen 5. Among 21 devices 14 are working on battery: 12 Hank door contacts and 2 Everspring Motion Sensor and are therefore sleeping most of the time. Everything works fine in normal time.
The problem I have is that when I stop and restart domoticz for any reason, the 14 on-battery sleeping devices loose their connection with domoticz and from there don't communicate anymore their status change when awaken (door opening or closing or motion detected) It is then a fastidious exercise of removing physically the 14 devices and re-include them.
Any idea of what the problem solution may be ?

[jeleve]

Hello,
Nobody encountered the problem ?
Surprising !
Help please.

[Alfagek]

There are a few problems with openzwave and Domoticz 2020.1.

Like this one: OZW-driver received fatal signal 11
https://r.tapatalk.com/shareLink/topic? ... ource=app

I have also some issues with my zwave devices. They are (I think) busy with the problem. Also on github there are some investigations


Verzonden vanaf mijn iPhone met Tapatalk

[renerene]

Same problem here. After reboot some (not all) battery zwave switches and motion detectors need to manually included.
Version: 2020.1 (build 11942)

[FreshMango]

Same problem here. After reboot some (not all) battery zwave switches and motion detectors need to manually included.
Version: 2020.1 (build 11942)

I have a similar issue.

[JuanUil]

See this post
https://www.domoticz.com/forum/viewtopi ... 24&t=32568