Cannot read Qubino 0-10v input

[jgaalen]

I'm trying to use my Qubino 0-10v to control my ventilation, which uses 0-10v input. But I'd like to use the current 0-10v as an input for the Qubino.

This Qubino has a 0-10v output and a 0-10v input. I was expecting that after connecting the z-wave device I would see a new device for output and a separate device for input. Unfortunately I do not see the input as a device, nor I see values in the z-wave config screen.

Anyone has an idea how I can read the input values? Others say it works on home assistent + open zwave, so I guess it should work in domoticz too.

Any help / suggestions are welcome!