I have recently purchased some new motorized blinds for my home, but unfortunately, these blinds are not "standard" (there from a small french company).
Anyway, there are using a RF Signal 433.92 Mhz, so normally compatible with the RFXCOM, raspberry pi and domoticz on it.
So I have managed to get the up/down/stop signal using the undec on on the RFXMngr on windows (so the RFXCOM does recognize the signal):
Packettype = UNDECODED RF Message
UNDECODED Blinds:xxxxxxxxxxxxxxxxxxxx (i have masked the signal)
So, having these raw signals, I have contacted the rfxcom company to try to add it to the firmware (but there kindda of busy right now).
Is there an other possibility, for instance in domoticz to configure a blinds switch by inserting a raw signal for up/down/stop button ?
If it is a frequent question, I am sorry, I am new to domotic and I have search down on google and in the forum without success.
Regards,
