NEO Coolcam Motion Sensor PIR

[arekbeben]

Hello,
this is my first topic, but i haven't found solve to my problem in other topics.

I installed Domoticz on my Raspberry Pi 3+, and connected to USB port Aeotec Z-Stick Gen5 (Z-Wave module). Then i connected to Z-Wave network my NEO Coolcam Motion Sensor. It show correctly temperature sensor and show temperature value in "Temperature" section, and show correctly lux value in "Utility". But i can't work with motion sensor.
In devices list i have:
-Alarm Type
-Alarm Level
-Sensor
-Burglar
-Alarm Type: Burglar 7 (0x07)

I turned on all of those devices and i have in "Switches":
-Alarm Type
-Alerm Level
-Sensor
-Burglar
All of those switches have "Light/Switch, Switch, On/Off" type. Alarm Type and Alarm Level are always off, but Sensor and Burglar switches changes their states (On/Off) but randomly. I was trying go out of the sensor area, wait a minute and go in, but i didn't found any logs in domoticz.
Did anyone have a similar problem or know how to setup correctly motion sensor?

[emme]

the 'Sensor' Device is the PIR and trigs by movement
Buglar is the tamper signal

honestly I discard all other devices which are more zWave mesh group related