Help making ducobox work with domoticz

[Basssment]

Hello,

I've read a lot of forum topics and websites about how to connect your ventilation to domoticz.
But I haven't figured out if this could word with my ducobox 325rf
I tried asking duco via the website but they didn't know exactly how to help.
Time to ask you guys

The ducobox controller is situated in the livingroom see pic.


Normaly it is on mode 2 and I can set it to mode 3 / mode 1 and the litle house modus.
after a while it wil reset to modus 2 again.

I opened the ducobox and found the following (pic).


There is no perilex kable just a normal 230v powercord.
I thought it would be possible to use an Qubino 0-10v dimmer and bought it but now I'm not shure how te install it.
The litle red end black wires are +/- the other wires I tried to measure but gave diffrent vaules so I dont know how to start.

Can someone guide me?
I am not an electrician and pretty new to this stuff

[SweetPants]

Without a proper schematic of the ducobox, this will be a complete guess.

[Basssment]

Looks Like the circuit board sends an frequence to the fan so i'm not shure if it is possible to word with the qubino dimmer.
What i did find out is that the co2 remote works with 868 mhz.
Could it be possible to make this word with domoticz in some kind of way?

Contacted the suplier but they could not tel me how the wireing works and don't know if it is possible to interact via 868 mhz with the ducobox.

[SweetPants]

Could it be possible to make this word with domoticz in some kind of way?

That would probably require specific hardware and some serious reverse engineering the signals from your remote. The RFLink seems to support 868 MHz, maybe these guy's can help you out!!

[Basssment]

Thank you for your reply.
I think i have tu figure out some other way than