After using Stable Build 4.9700 for a few weeks, I jumped the gun yesterday and updated my Domoticz installation to the latest Beta with build commit 5936d70. After installing this commit (and also commit 4b274d47 from today) I noticed that my Z-wave Danalock V3 gets an On / Off / On command when I try to unlock or lock the lock (this issue wasn't present in the latest Stable build). These On / Off / On commands happen within 10 seconds after pushing the button, and therefore I get a Z-wave Time-out from my lock in the Log and I'm unable to use Notifications on the lock as I get three messages. First I thought this had something to do with my lock so I excluded the lock from my Z-wave Network and rejoined it, but the same "problem" stays after rejoining the Z-wave and doing a full reset of the lock. I disable the event system as a test to be sure that not an Event was doing this, but also then the problem stays. The log of the Lock states the following:
Am I the only one who has this issue, or are there more people who have this issue? I did make a Back-up of my Stable installation, but restoring this would mean I would lose 1,5 days of Logging of my Solar Panels and P1 as I discovered this issue 1,5 after doing the update.
Danalock V3 On / Off / On Command
Moderator: leecollings
-
- Posts: 3
- Joined: Monday 08 October 2018 14:55
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: Danalock V3 On / Off / On Command
Hi
Related to your experience, did you had the danalock working on domoticz v4.97? I strugle with controling the danalock v3 with latest firmware.
can you share your experience with this?
thanks
Murat
Related to your experience, did you had the danalock working on domoticz v4.97? I strugle with controling the danalock v3 with latest firmware.
can you share your experience with this?
thanks
Murat
Who is online
Users browsing this forum: No registered users and 1 guest