Only 3 devices added after inclusion?

[renerene]

Hello,

After inclusion of my my Qubino Thermostat ZMNHID, only 3 devices are added; 2x kWh and coll/warm mode. No power options or temperature read-out.
The parameters of the device in the Z-wave hardware section seem ok

1) I'm used to having all devices right away, after inclusion. On forum I have read that some devices are added later. Is that true?
2) Does 'allow new devices (for 5 minutes' needs to be on? (tried it, with inclusion without success)
3) there are 2 XML configuration files for the ZMNHIDx : S1 and S2. How does this work? Do I need to change anything there?

[Tonio16]

Hello

I add the same problem yesterday for a plug of Fibaro, only 3 devices instead all of them, especialy the on/off switch of the plug.
I allowed new device and reboot the Pi. The other devices were there.

Regards

Antoine