Use "Enter" in output Telegram Notification

Brutus · Post by **Brutus** » Saturday 15 September 2018 18:37

Normally you can send a Telegram message in LUA with the following command:

commandArray['SendNotification']='Subject#Text: '..Sensor..'#0'

I would like to create a more clean output with an "Enter" after the text so the Sensor data comes on the next line in the message.

commandArray['SendNotification']='Subject#Text: "enter" '..Sensor..'#0'

Is this possible? I can't find any thing on Wiki or the forum.

Greetings.

SweetPants · Post by **SweetPants** » Saturday 15 September 2018 19:03

Have you tried adding "\r\n" to the string?

Brutus · Post by **Brutus** » Saturday 15 September 2018 19:08

SweetPants wrote: Saturday 15 September 2018 19:03 Have you tried adding "\r\n" to the string?

Thnx for your reply!

Can you please put that in my example? So i don't make a mistake.

SweetPants · Post by **SweetPants** » Saturday 15 September 2018 19:12

commandArray['SendNotification']='Subject#Text: \r\n'..Sensor..'#0'

Brutus · Post by **Brutus** » Saturday 15 September 2018 19:16

SweetPants wrote: Saturday 15 September 2018 19:12 commandArray['SendNotification']='Subject#Text: \r\n'..Sensor..'#0'

That works like a charm, Thanx!!

Were did you find this

?

SweetPants · Post by **SweetPants** » Saturday 15 September 2018 19:20

Brutus wrote: Saturday 15 September 2018 19:16
That works like a charm, Thanx!!

Were did you find this ?

It's just plane LUA, just googeld for it

Use "Enter" in output Telegram Notification Topic is solved