Zwave or klikaanklikuit sensor to read existing PIR

Topics (not sure which fora)
when not sure where to post, post here and mods will move it to right forum.

Moderators: leecollings, remb0

Post Reply
Hein73
Posts: 8
Joined: Sunday 09 September 2018 11:22
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:
Contact Hein73

Zwave or klikaanklikuit sensor to read existing PIR

Post by Hein73 »

HI,

Question: is it possible to use a zwave or klikaanklikuit device to read the status of an existing PIR? the devices I find either switch or are magnetic door contacts.

thnx!

kind regards,

Hein
Top
Ron
Posts: 82
Joined: Friday 27 December 2013 23:29
Target OS: Raspberry Pi / ODroid
Domoticz version: 2.2284
Location: Nederland, Den Bosch
Contact:
Contact Ron

Re: Zwave or klikaanklikuit sensor to read existing PIR

Post by Ron »

I think you can use the Fibaro binairy sensor for that.
I use them to build in a PIR sensor to transfer the status via Zwave to Domoticz.
Top
Post Reply

Return to “Other questions and discussions”

Who is online

Users browsing this forum: No registered users and 1 guest