I have a power meter that monitors electricity of the house.
I now have solar generation too.
I want to add the ability for some devices to be turned on when my electricity hits something like -2000 Watts.
Can I achieve this with blocky?
I tried a simple blocky but the off command were being sent far too frequently.
Thanks
Stuart
Sent from my SM-G955F using Tapatalk
Best way of achieving on command on meter readings?
Moderator: leecollings
-
stuiow
- Posts: 139
- Joined: Saturday 18 April 2015 18:56
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 3.6857
- Location: Isle of Wight, United Kingdom.
- Contact:
Best way of achieving on command on meter readings?
Now setup on a RPI3.
Also using Evohome HGI80, RFXTRX433E and a Aeotec Gen5 stick. Mainly a Gen5 Z-Wave system.
My weather (Davis vantage Pro2) data is obtained by weatherunderground
Now collecting rtl_433 data from Apollo Ultrasonic meter
Also using Evohome HGI80, RFXTRX433E and a Aeotec Gen5 stick. Mainly a Gen5 Z-Wave system.
My weather (Davis vantage Pro2) data is obtained by weatherunderground
Now collecting rtl_433 data from Apollo Ultrasonic meter
-
freijn
- Posts: 536
- Joined: Friday 23 December 2016 16:40
- Target OS: Raspberry Pi / ODroid
- Domoticz version: Stable
- Location: Netherlands Purmerend
- Contact:
Re: Best way of achieving on command on meter readings?
Hi,
There is a bathroom extract fan script in Lua. That one has a monitor in time steps.
I believe that would a good start to first check the status over a few minutes and then do the switching.
( no blocky sorry )
There is a bathroom extract fan script in Lua. That one has a monitor in time steps.
I believe that would a good start to first check the status over a few minutes and then do the switching.
( no blocky sorry )
Who is online
Users browsing this forum: No registered users and 1 guest