ZXT-120 and domoticz

[baddwarf]

Hi,

I just bought a ZXT-120 for domoticz as I saw that it should work. However, I can't get it working.

My hardware:
- RPi 2B
- Z-Wave.Me ZME_UZB1 USB Stick
- ZXT-120 v1.80
- Latest version of stable Domoticz

What I did:
- I'm able to include zxt-120 into z-wave network
- In ozcp, it appears as ready
- I'm able to request information
- I activated interrogation on the device (I don't know if it's the right word, I mean the checkbox just under device name)

The issue:
- Most of the time, when I try to set a code for air conditionner, I obtain the following messages in OZCP:

2017-12-10 22:29:37.830 Error, Node013, ERROR: Dropping command, expected response not received after 1 attempt(s)
2017-12-10 22:29:37.830 Always,
2017-12-10 22:29:37.831 Always, Dumping queued log messages
2017-12-10 22:29:37.831 Always,
2017-12-10 22:29:37.831 Always,
2017-12-10 22:29:37.831 Always, End of queued log message dump
2017-12-10 22:29:37.831 Always,

Domoticz translates it to :

2017-12-10 22:29:37.832 OpenZWave: Received timeout notification from HomeID: 3348869039, NodeID: 13 (0x0d)

- I get the same message when I try to send an action to the ZXT-120.

What I noticed
- I said most of the time because I succeed to change the code but I had to push the device button (which mean loss of effectivness for an automated solution)
- I'm not sure but I think that power method (usb or battery) changes the behavior.

My question:

Does anybody have any clue about what is happening here or any solution/workaround?

[baddwarf]

Hi,

Does anybody have a solution for this issue? Can someone help me debug this? Is there any information I can collect to get a status?

Best regards,