Has anyone successfully intercepted a rf signal from a Marmitek Powermid?
I was wondering if I could use domoticz to control my ir equipment and use my remote to control domoticz.
The Marmitek Powermid has an transmitter that transmits the incoming ir signal through rf (433mhz) to the reveiver which converts the rf signal to an ir signal.
compatibility Marmitek Powermid
Moderator: leecollings
-
fransiefrans
- Posts: 59
- Joined: Sunday 14 June 2015 13:22
- Target OS: Raspberry Pi / ODroid
- Domoticz version: stable
- Location: Netherlands
- Contact:
-
rednas
- Posts: 132
- Joined: Tuesday 20 October 2015 12:23
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Location: Netherlands
- Contact:
Re: compatibility Marmitek Powermid
I am also interested in using a Powermid but I am unable to find out whether I can use it with Domoticz..
-
fransiefrans
- Posts: 59
- Joined: Sunday 14 June 2015 13:22
- Target OS: Raspberry Pi / ODroid
- Domoticz version: stable
- Location: Netherlands
- Contact:
Re: compatibility Marmitek Powermid
Still nobody who got it tot work?
-
sion
- Posts: 113
- Joined: Friday 08 January 2016 12:32
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: compatibility Marmitek Powermid
Did anyone try this?
running domoticz 3.4834 on rpi2, with
Hue bridge / bulbs.
lightwave rf sockets, mood controlers, sensors & contacts.
Home bridge / Siri.
Ha bridge / echo Alexa.
Hard wired alarm system - setting home / away status.
Next: harmony hub.
Hue bridge / bulbs.
lightwave rf sockets, mood controlers, sensors & contacts.
Home bridge / Siri.
Ha bridge / echo Alexa.
Hard wired alarm system - setting home / away status.
Next: harmony hub.
Who is online
Users browsing this forum: No registered users and 1 guest