Blocky set for X minutes does not work?

Moderator: leecollings

Post Reply
knifto2
Posts: 3
Joined: Sunday 04 December 2016 13:27
Target OS: Raspberry Pi / ODroid
Domoticz version:
Contact:

Blocky set for X minutes does not work?

Post by knifto2 »

I bought some door sensors, however these sensors only sends an OFF command when the door is opened.

I want an dummy sensor (Schuifpui) triggered ON or OPEN for 30 seconds and put the sensor (Schuifpui-Sensor) back to the ON state (so it is in the right state to receive another OFF command);

So I made this blocky (see attachment).

The dummy switch is set to ON, but never returns to off.

What am I doing wrong?
Attachments
Knipsel.PNG
Knipsel.PNG (12.77 KiB) Viewed 1080 times
spikehome
Posts: 24
Joined: Friday 04 March 2016 15:13
Target OS: -
Domoticz version:
Contact:

Re: Blocky set for X minutes does not work?

Post by spikehome »

The 30m block is a time block.
Use the nummer block
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest