Slave with extra Z-wave controller expand signal? Topic is solved

[jenssen]

Hello,

When you have a master Pi with a Zwave USB controller attached to it, and you expand it with a slave Pi, is it also possible to add an extra Zwave controller on the slave unit? I only want to use the extra Zwave controller on the slave Pi to extend the Zwave signal.

Kind regards,

Hugo

[Egregius]

Is your home that large that the mesh network isn't enough?

[jenssen]

Is your home that large that the mesh network isn't enough?

well I just want to add the Z-wave controller to the Pi so that it is part of the mesh network, just as the other controller. Is that possible?

[Egregius]

2 controllers in 1 network?

[jenssen]

2 controllers in 1 network?

yes, but not as an active controller, but only as "supporting" the mesh network?

[Egregius]

I don't know what you want to achieve with that. Any powered node is a repeater.

[jenssen]

I don't know what you want to achieve with that. Any powered node is a repeater.

only to have a better zwave mesh network, as I do not have so much active zwave components (a lot of them are on battery), that is the only reason. Is that possible?